Topics created by Mati

Hello everyone,

I just wanted to chime in and mention that with UIFlow firmware 1.7.1.1 that I also do not have the RGB leds showing up as hardware options in block view in the UIFlow IDE. I do not have the "Set bus power mode" as an available block. I CAN however call rgb.setColorAll() and other rgb functions from the python code and get the correct output from the LED strips on the Core2 M5go Bottom2 hardware. So I am not sure what that means as far as where the bug is.

Thank you!

@zappawaddawadda Look me up on Github as I post stuff there, I haven't updated the E-Ink docks in ages due to Core2 AWS and massive software dev issues on OSX.
UIFlow 2.0 is coming next year so expect an update.

@mati Hmn, I think you could be correct there with the backend.
Put a hold on the project and try again in a couple of days or drop a bug report on the UIFLow github page.

done as BUG https://github.com/m5stack/UiFlow-Bug-Report/issues/12

@grlind I was able to get to work in Ardunio I just combine the DHT into the main sketch all things good though the pressure reading are off... I owuld like to see the uflow - I have not done anything in uflow want to try it.. Is your code posted somewhere?

@mati said in Windows M5Burner Proxy support:

@lukasmaximus well this is a issue only in proxy restricted networks. So its non critical or blocker.
Its could be add to considering in next MBurner sprint.

Thx for reply Lukas

A proxy restriction network? Would installing a VPN service not be better?

Done http://forum.m5stack.com/category/33/m5stick-v

Yes, you can custom serials of blocks for FACES Kit.