@ajb2k3 Got it now thanks. I was trying to use the UIFlow 1.X example.
Bipman
@ajb2k3 Got it now thanks. I was trying to use the UIFlow 1.X example.
Bipman
@teastain I've tried the BME280, the heart rate monitor, the OLED Unit to name a few.
Bipman
Hi
I have the Pa Hub (PCA 9548AP). WHen I plug it into the Core S3 it registers it's address and shows up on the i2c bus but anything plugged into it doesn't. The units work fine directly connected though. I.e. code works on sensor directly plugged in but does not when the hub is used and the sensor is plugged into that. Do I need a driver or am I doing something wrong?
Bipman
Hi
I've set up a quick test program in Uiflow for deep sleep and wake up and to test the Env Pro sensor. I've set it to deep sleep after 15 seconds and then wake after 5 seconds. All works OK until it wakes up as it seems then to sleep and wake every approx. 5 seconds. The code is the following so I'm not sure why it isn't sticking to the 15 second sleep.
Am I doing something wrong here?
Bipman
Hi
I'm trying to get the gas value from the Env Pro unit but it never seems to change from 0.0. I've tried heat, smoke etc. but it never changes. Am I missing something or are there parameters not in the UIFlow library I need to set?
Bipman
@felmue
Thanks, I've just tried it and no difference. The code is :-
I've noticed that the Python code does not change when I add the external port power item in.
The voltage is still 0.5v though on the port. Am I missing something?
Bipman
Hi
I have a CoreS3 which I am trying to get the Env pro sensor working with. The Uiflow 2 example did not work in that it couldn't find the module. I measured the voltage on Port A (red) and it was only 0.5 V. Is it a defective unit?
Bipman
@ajb2k3 Got it now thanks. I was trying to use the UIFlow 1.X example.
Bipman