My DInmeter is intended to run on battery power. I set G46 to HIGH immediately in setup but the unit shuts down after a few seconds.
I cannot get the unit to start by pushing the encoder button. I must plug in the USB cable to start it. After I remove the USB cable, issue #1 happens - it shuts down in a few seconds.
Does anyone know of an example where a DinMeter runs exclusively on battery, starts when the encoder button is pressed and stays running as long as G46 is High?
Having no luck waking up my M5DinMeter from hibernation using the encoder button on G42. Anyone figure this out? My DinMeter runs on battery so using the USB plug is not what I'm looking for.
Wayne in Manchester NH USA
haven't been able to operate the GoPlus2 module with the Atom Lite. Have grove connector from Atom pins 26,32 to PORTB1 of GoPlus2. GoPlus2 is powered by 12v and two 5g servos are connected.
I2C scan does not return a device.
setup includes:
M5.begin(true, true, false);
Wire.begin(26,32)
Anyone had success with this setup?
Wayne in New Hampshire