DINMETER Battery Power
-
-
My DInmeter is intended to run on battery power. I set G46 to HIGH immediately in setup but the unit shuts down after a few seconds.
-
I cannot get the unit to start by pushing the encoder button. I must plug in the USB cable to start it. After I remove the USB cable, issue #1 happens - it shuts down in a few seconds.
Does anyone know of an example where a DinMeter runs exclusively on battery, starts when the encoder button is pressed and stays running as long as G46 is High?
-
-
Hello @wrs642
from this and your previous post I would guess that there is no battery connected or it is not charged (enough).
Thanks
Felix
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login