Problem solved.
To change the I2C address of a Kmeter one need to write to register 0x08 the new address (one byte) and to register 0x09 the same address but with the bits converted (1 is 0 , 0 is 1).
After writing cycle the power.
Thanks to M5 technical help team.
M
Best posts made by meirmark
-
RE: Change the I2C address of a Kmeter Unit
-
industrial friendly mechanical installation
Hi.
As I understand from your site You are pointing to the industrial IOT world .
I am using the M5Stack cores, modules and sensors for industrial machines and have sometimes a problem to install them physically because the mounting holes is for Lego (not very industrial grade) and not for normal bolts.
Also in some sensors there isn't any flat bottom that can be attached to a surface .
Maybe is time to decide if you are industrial or hobby oriented .Meir.
-
Modbus TCP with a LAN module
Hello.
I am trying to use a M5core with LAN module to make a modbus TCP slave.
I tried a few Arduino samples but nothing works.
Can somebody help ?Thanks
-
RE: [Product] - Industrial 24VDC DI, DO, AI, AO
A module or a unit with digital I/O expender that have a PNP or/and NPN interface (24 v) can be very useful .