Best posts made by Kombistack

Hello everyone,
Can anyone please advise if the UnitCam can be used with the M5Stack Core2?
The Cam Unit is greyed out in UiFlow.
If the UnitCam can be used with the Core2 I presume it needs to be wired to the pins beneath the CORE2 cover on the rear of the M5Stack Core2.
Any help greatly appreciated.

Amazing! Thank you very much Pavelprosto.

@kombistack Well I don't know how I did it but I managed to get my AtomS3 Lite to connect to the cloud using the USB driver
and then using the Web Burner in UIFlow 2 to first erase the device and then reinstall the program.

Hi Felix,
PROBLEM SOLVED!
You are right. When I removed the CORE2 cover and replaced it with only slight pressure the controller boots up.
SO the trick is not to push too hard and push the cover too far in, or as you say isolate the metal parts with tape.
Thank you for problem solving this for me and probably for others who have the same issue.
Cheers

Thanks teastain,
yes the heart rate unit is useless. It does not produce accurate results no matter how much you try and adapt the way you use it.

@kuriko Thank you

Thanks ajb2k3,
I did manage to get my Stamp Pico working with both a PIR sensor and relay unit.
The problem was my fault. In soldering on the grove connector to the Stamp Pico, I soldered it on the wrong side of the board so when I connected a grove cable - ground was connected to GPIO 33, 5v was connected to GPIO 32, GPIO 32 was connected to 5v and GPIO 33 was connected to ground. Fortunately I didn't cook my board.