m5stick c plus 2 not turning on
-
recently i bought an m5stick c plus 2 and i downloaded nemo
it was working normally but 2 days later my stick wasnt bootingwhen i hold the on/off button appears an green light but the screen doesnt turn on
when i try to burn something in the m5burner this is what happens:
Detecting chip type...
ESP32
Chip is ESP32-PICO-V3-02 (revision v3.0)
Features: WiFi, BT, Dual Core, 240MHz, Embedded Flash, Embedded PSRAM, VRef calibration in efuse, Coding Scheme None
Crystal is 40MHz
MAC: e8:9f:6d:32:e2:58
Uploading stub...
Running stub...
Stub running...
Changing baud rate to 1500000
Changed.
WARNING: Failed to communicate with the flash chip, read/write operations will fail. Try checking the chip connections or removing any other hardware connected to IOs.
Configuring flash size...
Warning: Could not auto-detect Flash size (FlashID=0xffffff, SizeID=0xff), defaulting to 4MB
Flash will be erased from 0x00000000 to 0x00289fff...
Compressed 2660976 bytes to 1589191...A fatal error occurred: Packet content transfer stopped (received 8 bytes)
help pls
-
@cmcrrr Maybe the Nemo hacking software hacked you?
This happens so often I am starting to suspect that Nemo has itself been hacked.
You should contact the wider Nemo hacking community. and see any fellow hackers are experience this problem. -
@cmcrrr can you try to use M5Burner and go for ERASE before burn? Or just try to load EasyLoader file for M5Stack? or just load siple sketch from Arduino?
-
Hello @cmcrrr
you might want to force M5StickCPlus2 into download mode manually. Below are the steps:
- disconnect USB
- press and hold PWR button until green LED lights up, then release button
- connect a wire from G0 to GND
- attach USB
- press and hold PWR button until green LED lights up, then release button
- remove wire
--> M5StickCPlus2 is now in download mode. - Use M5Burner to erase or flash something.
Thanks
Felix