Hello, i'm testing the FaceDetect V-Function of the M5Stick, connect with Grove cable to an M5StickC. I did a simple program on UIFlow wich prints on the display the numbers of faces detected by the StickV, but it seems to detect nothing because the number is always 0. I have burned the StickV with the firmware on M5Burner and i added the UnitV on UIFlow, but the two don't seem to communicate. Some one can help me?

Hi, i'm trying to boot M5StickV following the steps of this page (https://docs.m5stack.com/en/related_documents/v-training), but when i insert the sd-card and turn on the StickV, the screen not show the display Training, moreover if i try to run the boot.py code on MaixPy IDE i get: "error: cannot find start.jpg", even if i insert the required files in the sd.
Thank you for help.

Hi, is the AI camera M5Stack UnitV1 out of stock?

what unit of measurement does the input I give to the SetPulse block of the hat bugC have?

Hi, i need to install an omnidirectional wheel on the bala.c set, i thought about a lego adapter, do you have any advice?

how to generate a sinusoidal waveform on UI flow using an m5 stick C plus connected to a DAC device?