Posts made by ankit17340

Hi @felmue

Yea I am able to erase and upload the firmware through the serial connection.

Thanks

Hello @felmue,
I have tried with and without connection, I am not able to access the configuration of the pico stamp. Do I need additional connections or drivers for this?
Here is an image of my connection:

Hi @felmue

I have tried I am not able to open the configuration, it just stuck on loading so I was not able to use it. Is there any other way of switching modes?

Thanks for the Help

I have been trying to switch between wifi to USB. I followed the guide at getting a quick start with micropython and change the mode to USB. My led is glowing blue as suggested in the guide but it has been stuck at uiflow as if it is waiting for connection with wifi. Is it possible to completely remove these modes as for my current situation I don't need the WiFi. The image below shows where it is stuck: