Fire with UIFlow2
-
Hi all,
i'm new to the M5Stack universe. I got my Fire 2.7 today and tried to upload the UIFlow2 Firmware for fire.
Flashing is working well (i also get a success message, hash was verified, ....), but the device is dead after flashing.On the serial monitor i can see that something is corrupted:
Rebooting... ets Jul 29 2019 12:21:46 rst:0xc (SW_CPU_RESET),boot:0x17 (SPI_FAST_FLASH_BOOT) configsip: 0, SPIWP:0xee clk_drv:0x00,q_drv:0x00,d_drv:0x00,cs0_drv:0x00,hd_drv:0x00,wp_drv:0x00 mode:DIO, clock div:1 load:0x3fff0030,len:4912 load:0x40078000,len:15532 load:0x40080400,len:3696 entry 0x400805e0 [0;31mE (1766) esp_psram: SPI SRAM memory test fail. 347/131072 writes failed, first @ 3F80B420 [0m [0;31mE (1766) cpu_start: External RAM failed memory test![0m abort() was called at PC 0x40081ae1 on core 0 Backtrace: 0x40082605:0x3ffe3b90 0x40098181:0x3ffe3bb0 0x4009ba71:0x3ffe3bd0 0x40081ae1:0x3ffe3c40 0x40079630:0x3ffe3c80 |<-CORRUPTED
I also tried different version, but without any success. Is there any possibility to work with the Fire and UIFlow2?
Thank you very much!
Best,
André -
@a-wussow Did you use M5Burner?
Did you erase before burning?
Did you select the correct firmware version? -
@ajb2k3 Thanks for your response.
Yes, i used M5Burner and also tried erase before burning.
I selected "UIFlow2.0 Fire".But in the meantime i worked with Arduino IDE and tried it again. After flashing with Arduino, Erasing with M5 Burner and Flashing again with M5 Burner its now working. Strange ...
Thank you.
-
@a-wussow Glad to see you got it working again.