cardputer stuck on develop
-
Have you installed ESP-IDF?
-
@ajb2k3 sure mate, after all, I redo all my steps and following the youtube video finally works.
many thanks and tons of likes!!
-
@ToxicAvenger hi i got a new core s3 and was not aware of this boot mode and the error was also occoring to me but on sync screen but on the core s3 to fix it i have to hold the reset button until ther green light turns on then only it started to upload new uiflow so for the cardputer it might be the same problem and also try using a diffrent usb cable.I was using wifi upload and it crashed during sync
software info and hardware
board : m5stack core s3
MCU : esp32s3 extenza lx7
uiflow vertion : 2.0.7
arduino ver : 2.1.0
windows 10 -
@ROLF_STEINER
M5Stack documented this for each device. "Press G0 while booting...." or similar. Yes, I had problems too.
