cardputer stuck on develop

[Ruelvillo]

When in doubt, G0 and RST it out, hold G0 and tap RST and then let go of G0.

[wilsoreal]

has anyone found a solution, i am having the same problem

[ajb2k3]

@wilsoreal said in cardputer stuck on develop:

has anyone found a solution, i am having the same problem

Have you watched the video I linked to above?

[wilsoreal]

@ajb2k3 yea but still cant erase my sd and when i try to navigate anything in UI flow 2 it just doesnt work

[ROLF_STEINER]

hi guys!!! same thing here too....
I used multiple cables (no result)
I updated softwares like a collector in a bunch of them...(same results)...
im absolutely lost....
so if someone see the light please share the trick... Captura de pantalla 2024-05-17 a las 00.16.41
Captura de pantalla 2024-05-17 a las 00.16.54
Captura de pantalla 2024-05-17 a las 00.17.05
Captura de pantalla 2024-05-17 a las 00.19.24

[ROLF_STEINER]

@rolf_steiner Captura de pantalla 2024-05-17 a las 00.16.41

Captura de pantalla 2024-05-17 a las 00.16.54

Captura de pantalla 2024-05-17 a las 00.17.05

Captura de pantalla 2024-05-17 a las 00.19.24

[ajb2k3]

Have you installed ESP-IDF?

[ROLF_STEINER]

@ajb2k3 sure mate, after all, I redo all my steps and following the youtube video finally works.

many thanks and tons of likes!!

[mnhj]

@ToxicAvenger hi i got a new core s3 and was not aware of this boot mode and the error was also occoring to me but on sync screen but on the core s3 to fix it i have to hold the reset button until ther green light turns on then only it started to upload new uiflow so for the cardputer it might be the same problem and also try using a diffrent usb cable.I was using wifi upload and it crashed during sync

software info and hardware
board : m5stack core s3
MCU : esp32s3 extenza lx7
uiflow vertion : 2.0.7
arduino ver : 2.1.0
windows 10

[elektron2kim]

@ROLF_STEINER
M5Stack documented this for each device. "Press G0 while booting...." or similar. Yes, I had problems too.