M5stick GREY upload/flash problem
-
Hi everyone,
I've recently bought an m5stick GREY in particular for it's 9-axis sensor.
I've uploaded the stickwatch.ino with arduinoIDE (following step by step both the arduino IDE and the stickwatch guides).
Willing to try out the uiflow ide i tried to connect it and to burn the UIFlowv1.2.3, therefore using the button Erase, before trying to Burn it.
The result is the known problem:
Since then i'm stuck with the Stickwatch sketch installed, and i can't upload anything else.
I even tried "EasyLoader_M5Stick_FactoryTest" with no results.Please Community-Senpai you are my only hope.
BaDjinn
-
Check your cable, it may have chosen this moment to fail,
You need to click ERASE first before burning.
Try changing the Baudrate,
Try a different cable. -
I've solved the problem by tempering with the "reset" button, erased, used EasyLoader_M5Stick_FactoryTest and after that tried a few exemples in the arduino IDE.
Sadly now i'm again in the same problem as before: I've successfully uploaded the example "helloServer" to tryout the server capability/interface/library...and all works well...but now i am in no way able to flash anyting new on it.
I tried as you (aib2k3) said to switch cables and USB port, tried my trick on catching the right timing with the reset button, but to no avail.Can you help me?
-
Solved, it was a problem with the Silicon bridge drivers. I uninstalled it and it worked like a charm. 😁
-
@badjinn said in M5stick GREY upload/flash problem:
Solved, it was a problem with the Silicon bridge drivers. I uninstalled it and it worked like a charm. 😁
Glad to hear it, they can be an issue on their own