Upload error w Arduino IDE - A fatal error... Timed out waiting for packet header
-
Hi M5Stack C sitting on win 10 (Dell XPS 15), COM5. EasyLoader looks to connect and work fine. But, Arduino IDE runs into this problem when trying to upload a sketch("Hello World").
I have tried different things, like connecting GND-G0 and 3V3-G0. No success.
Messages:
Sketch uses 254233 bytes (19%) of program storage space. Maximum is 1310720 bytes.
Global variables use 16676 bytes (5%) of dynamic memory, leaving 311004 bytes for local variables. Maximum is 327680 bytes.
esptool.py v2.6
Serial port COM5
Connecting.....
Chip is ESP32-PICO-D4 (revision 1)
Features: WiFi, BT, Dual Core, 240MHz, Embedded Flash, VRef calibration in efuse, Coding Scheme None
MAC: d8:a0:1d:56:47:60
Uploading stub...
Running stub...
Stub running...
Changing baud rate to 921600
Changed.
Configuring flash size...A fatal error occurred: Timed out waiting for packet header
A fatal error occurred: Timed out waiting for packet header -
That isnt a big trouble.A photo about it is helpful...
you can try to dissconnect from your USB port and then reconnect and upload.Do not touch the line while you are uploading.
I think you touched the USB line while uploading. -
Have you tried changing the baud rates?
There are many reasons for the timeout. -
Hi， you should selcet M5StickC board in ther board manager. or seting the baud rate to 115200
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login