Step Motor Module

ajb2k3

BTW, you are aware that its the new year and everything is shut down thill the 12th?

cepics

@cepics said in Step Motor Module:

thanks, I will try with NEMA 17 12v.....

You will need to adjust the drivers as they are not calibrated by default.

How can I calibrate the drivers?

Can I Use this motor?

Angle of step: 1.8 degrees.
Voltage: 12 V
Current: 1.2 A / phase.
Resistance: 10.0 ± 10% / phase.
inductance: 20 ± 20% / phase.
Support moment: 68 g / cm2.
Number of wires: 4
Support time: 48 min. N. cm.
Large braking torque: 2.6 N. cm.
Insulation class: B

ajb2k3

Ebay link?

Calibration is done via the tiny silver round thing on the individual stepper driver.

cepics

@ajb2k3 said in Step Motor Module:

Ebay link?

NEMA 17 MOTOR

@ajb2k3 said in Step Motor Module:

Calibration is done via the tiny silver round thing on the individual stepper driver.

thanks a lot !!

something like this ?

ajb2k3

Yes, just like that.
Don't connect any steppers when calibrating it!

cepics

@cepics said in Step Motor Module:

NEMA 17 MOTOR

can I use this motor with the step motor module?

can I power the core and the module with 12v ?

ajb2k3

@cepics

yes the nema 17 will be fine.

I'm sure that the m5 will receive power from the module but i'm not certain.
you will need external power to the module to power the stepper.

cepics

I will try ....

thanks

Kryten

@ajb2k3 Do you have any good scource for wires for the stepper output?

I have several sets of stepper motor wires but none that fit in the stepper module

ajb2k3

@kryten the stepper module uses the standard Grove cable system so cutting off the existing wire connections on the stepper motor and replacing them with a grove wire harness works fine for me.

Kryten

@ajb2k3
Thank you very much.

I hope to get some wires sorted out soon so I can see if I manage to get the module working on a "printer" (2D drawings)

ajb2k3

@kryten said in Step Motor Module:

@ajb2k3
Thank you very much.

I hope to get some wires sorted out soon so I can see if I manage to get the module working on a "printer" (2D drawings)

My pleasure

cepics

can I use this motor with this module?

ajb2k3

@cepics said in Step Motor Module:

can I use this motor with this module?

It looks like it should work but you would need to adjust the drivers. I don’t have one so I can’t say for certain but it is a 4 wire stepper