H-Bridge PWM signal to Papst 4412 FGMPR Vent doesent spin Backward at 60% PWM ??
-
I´m new here, hello.
Can someone help me out how to use a H-Bridge to correct regulate the 0-40% and 60-100 % PWM Signal.
This Vent has the special Possiblility to Spin in both Directions, vorward and Backward with the correct PWM Signal.
Here is the Sheet to it:
https://docs.rs-online.com/d48e/A700000006464999.pdf
It sounds easy to just use 40% or 60% PWM Rate to get the Result.
But sadly, it doesent do what i want it to do.
I ended up now with sending the PWM signal, vs. not Pluging the PWM Signal at all.
This lets the Fan spin in the Opposit direction.
It´s confusing, i cannot understand what the Problem here is but it works now how i wanted it.But what do i wrong ? Is it the wiring or the Setting, or the wrong Module ?
I need a PWM Module that can work in on a i2c A Hub, for the Possibility to regulate 4 Fans seperate with Individual settings.
Any recommendations for this task, what i can use for it ? -
@NoobCheck1 Connect the power and grounds to a sufficient power supply. No H bridge needed!
You fan works like a M5Stack 360 deg (Continuous) RC hobby servo.
Here is code.
https://github.com/m5stack/M5-ProductExampleCodes/tree/master/Accessory/ServoKit180_360/Arduino/ServoKit180_360
I have not tried it but I have done 360 servos...and this is the M5Stack 360 example.
And a PbHub should work. -
@teastain Hi teastain, thank you for your reply with this Informations. Sadly i thougt i need this H bridges, and bought them all. So now i use them with the possibility up to 10000 frequency. One Set of Vents would need 25000 frequency, but they work also with 10000. The others only need 2000-4000 frequency, and happy with the value it can deliver. And i have no idea how to use 5 set of Fan´s with the onboard PWM and different Values.
The Hub-B can deliver PWM, but i cannot choose the frequency, so i not try to use this device, because lower frequencys at 2000-5000 with the 25000 frequency Fans produce very noisy Fan Sounds. But at 10000 it is ok to hear.On the End, i´m happy the Fans i have can be used with the M5stack H Bridge Units.
The next i need to do is, how to use Servos, to Automatically set the height of the Lamp.
But how i can Stop and Hold a Servo, also without a Power Source to hold the weight ?
Are there some M5stack Units and Servos i can use with a weight of 2-3kg ?
They should lift and securely stop lifting in a Range of 1 Meter.
I looked up some RC Winds and a Servo Unit, but the Most of them have no rachet stopper, and for now i have no idea what devices i can use easily for this task.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login