Dear all,

I am a total newbie with two projects in mind. One will use loadcells so I thought I start with this kit to get used to the whole topic.
I tried UiFlow2 as well as Arduino IDE, but I don’t get feasible results.
UI gives me at least a reading of values but they are never stable and don’t make sense at all. Tried the calibration function and everything. But … no.
Arduino IDE I don’t get any values. Only 0.00.
so I guess I did something wrong in the PIN allocation.

Or is the whole thing defective? But normally I would see my lack of knowledge as the root cause of my issues.

Anyone outthere who can help me out?

best regards
Timo