UIFlow 1.8.3
-
Ver 1.8.3 time: 2021.0827
v1.8.3
new features:
- Add UNIT FADER support
- Add Module stepmotor driver support
- ESP-NOW support encrypt(LMK)
- New Vfunciton for UNIT V2
Bug fix:
- Fix NB-IoT MQTT downlink data parse error
- Fix ATOM-DTU Modbus UART ID error
-
good job! when will the desktop IDE be upgraded?
-
RGB leds won't work on M5Stamp if pins set to anything other that PORTA
-
I am beginner of M5Stack. I bought both M5Go and Fire, together with lots of units. When I test the OLED unit, I found it always show M5 logo with "M5STACK". i can 't fill with black or white. I can't draw rect. I can't draw line. I can't draw text. The only function works is "invert" but still only M5 logo with "M5STACK" is shown all the time. I tested it with both M5Go and Fire but same problem. Any help?
-
with uiflow the OLED-unit shows nothing else than the M5Stack logo
-
add this block after any draw.
-
The range of ids of the Set id block in myCobot is wrong. It should be from 1 to 6, but from 2 to 7.