Is the interrupt pin of MPU9250 connected to the ESP32?
-
Hello,
I am trying to get acceleration readings at a constant rate of 200 Hz. If the interrupt pin of the MPU9250 was connected to the ESP32 of the M5Stack Grey this should be straightforward however, I am struggling and haven't found much information on this topic. Therefore I would like somebody to confirm that the interrupt pin of the MPU9250 is actually connected to the ESP32 and can be used.
Thanks for your time.
Cheers,
SpeedyG -
Hello @SpeedyG
my M5Stack Gray (which uses an MPU6886) did not have the interrupt connected to ESP32. I assume that is the case with your (earlier) M5Stack Gray version as well.
That said, here is how I connected the missing interrupt wire.
Thanks
Felix -
Hello Felix,
thanks for the info on your M5Stack tuning. I opened the case and managed to get to the MPU9250 however, I am quite sure that I would burn something considering the tools I have. I took a photo of the MPU9250 with the 1.5mm Allen key next to it just to give an impression of size.
I have purchased some ADXL355Z and will try a "conventional" solution. BTW, to open the case I followed the instructions given here (https://forum.m5stack.com/topic/257/replace-cracked-screen/6).Cheers,
SpeedyG