Proto Module could be more useful
-
The PROTO module is kind of an poor design. It is just a perf board. It would have been more useful to at bring out the header pins to solder points on the PCB. The way it is now you have to solder wire to the SMT pad under the header. Makes no sense. Also, bring out the 3.3, 5V, and GND to busses so they can be used. I am just going to make my own proto module. I finally managed to locate the Samtec header part number but they take a few weeks to get.
-
Could you share the Samtec header part number and the seller's link ?
-
This might be helpful to you.
-
Fully agree on this one.
Having access to the bus signal would be a minimum.
Hello! It looks like you're interested in this conversation, but you don't have an account yet.
Getting fed up of having to scroll through the same posts each visit? When you register for an account, you'll always come back to exactly where you were before, and choose to be notified of new replies (either via email, or push notification). You'll also be able to save bookmarks and upvote posts to show your appreciation to other community members.
With your input, this post could be even better 💗
Register Login