myCobot 280-M5 communication
-
Hi all,
We recently purchased a myCobot 280 that runs off of the M5-stack but I am having trouble getting the unit to communicate with UiFlow software to upload code to manipulate the robot.
I believe the issue lies with the drivers. There is a driver by the name of 'Silicon Laboratories (silabenm) Ports' that is not properly installing on my computer.
Any ideas or suggestions?
The installation wizard says to run the installation wizard again, but it did not make a difference. -
Delete the driver, shut down the computer (Full power off for 30 seconds) do not plug in the usb cable to the core!
Install the driver linked to on the page and then full shutdown the computer again. Boot the computer and when finished booting plug the usb cable and power cable in to the arm and check the system hardware that the new port is working.
