Port "E", Port "Custom" and Pogo
-
Hi all,
Port "E", where can I find it?
Port "Custom", these are pins from the bus, right?
Pogo pins, they are only for charging, right - using them as interface is not possible?
Sorry for these question, but due to my experience regarding docu - its poor - the available docu ;-)
KR,
Uli -
Port "Custom" is used for defining pins that are not set as the default port A B and C.
For example, if you wanted to connect an 2nd unit to a stickC you would chose the custom and then set the tx and rx pins to two of the pins from the hat connector.
As to port E well, I'm yet to find out. -
@uli said in Port "E", Port "Custom" and Pogo:
Pogo pins, they are only for charging, right - using them as interface is not possible?
According to the product page, the pogo pins can also be used for I2C (GPIO 21 and 22) on supported devices (BALA)
https://docs.m5stack.com/#/en/base/m5go_bottom?id=pinmap
