<![CDATA[Tough Touch Help!]]>I'm trying to read touches on the Tough screen, but when I start the code, it already comes with values ​​of X (52) and Y (154) as if there was a touch.
By chance, it's exactly in the area where I expect it to be touched...
When I read the data in:

uiflow2_block_1731087302359.png

I get the following response: (52.0, 0.0, 154.0, 0.0)

I'm trying to read the touch like this:

uiflow2_block_1731087721755.png

Thank You!

]]>https://community.m5stack.com/topic/6969/tough-touch-helpRSS for NodeFri, 13 Mar 2026 11:05:15 GMTFri, 08 Nov 2024 17:39:32 GMT60<![CDATA[Reply to Tough Touch Help! on Thu, 14 Nov 2024 11:48:41 GMT]]>@felmue

Thanks again, you're the M5man!

]]>https://community.m5stack.com/post/27036https://community.m5stack.com/post/27036Thu, 14 Nov 2024 11:48:41 GMT<![CDATA[Reply to Tough Touch Help! on Sat, 09 Nov 2024 16:04:28 GMT]]>Hello @cryptospok

please find an example in the UIFlow2 Project Zone: M5ToughTouchTest_UIFlow2.1.7 showing how to get rid of old / duplicate touch events.

Thanks
Felix

]]>https://community.m5stack.com/post/27000https://community.m5stack.com/post/27000Sat, 09 Nov 2024 16:04:28 GMT<![CDATA[Reply to Tough Touch Help! on Fri, 08 Nov 2024 18:44:40 GMT]]>I noticed that if I turn Tough off and on again, the initial coordinates are -1 and 1, but if I just load a new version of the code, the last coordinates remain...
How could I clear the coordinates at the beginning of the code?

I also couldn't use the following block:

uiflow2_block_1731091448273.png

Thanks for any help!

]]>https://community.m5stack.com/post/26996https://community.m5stack.com/post/26996Fri, 08 Nov 2024 18:44:40 GMT